SHINESTAR 6FT Stainless Braided Propane Regulator with Hose, Low Pressure LP Hose and Regulator for QCC1/Type 1 Tank and Gas Grill, Smoker, Propane Fire Pit, Heater, 3/8 Female Flare Nut, CSA

1.Please check to see if the propane tank has the standard propane valve fitting QCC1/Type1, like a Gas Grill, Heater, Fire Pit and Generator. Then see device if the other end is a 3/8inch Male Flare Fitting.
2.The output pressure of the regulator is set to 11 inches water column which equates to approximately.
3.Low pressure means the high pressure in your propane tank will be reduced and regulated to the correct pressure for your burners to work as designed.

Product Specification:
Certificate : CSA
Outlet Pressure:11”W.C.
Flow Capacity: 80000 BTU/Hr
Material: Stainless steel braided
Length: 6 feet /72 inch (length of rubber hose only)

Attention:
1. Warning!!! For your safety ALL propane appliances like gas grills, heaters and stoves are OUTDOOR Use.
2. FULLY TIGHTENED at both propane tank side and grill side before using on your propane appliances to prevent leakage.
3. To check and make sure the hose is away from the OPEN FIRE before installing to your appliances.
4. Keeping the hose away from HIGH TEMPERATURE.

NOTE:

– Pay attention of the sharp edges when unpackaging and installing, better wear gloves

Product Features

• 72” Braided stainless steel Low pressure propane regulator and hose assembly
• Designed to fit most gas grill, propane smoker, fire pit, propane heater. 6-feet long
• Acme nut (QCC) x 3/8” Female Flare Fitting; Outside diameter of 5/8″
• Replaces hose and regulator on Type-1 connection with burner stove
• CSA certificated; Provides secure, airtight connection between grill and tank