Product Specification:
Hose Length: 2 feet/ 24 inch
Regulator Type: Low Pressure
Gas Type: LP/LPG
Inlet Diameter:QCC or POL
Outlet Diameter: 3/8” Female Flare Fitting(5/8-18UNF)
Inlet Pressure：25-250 PSI
Outlet Pressure:11”W.C. 
Flow Capacity: 80000 BTU/Hr
Certificate : CSA

Attention:
1.When the flame gets low or no gas comes out through the regulator, please turn off the propane gas tank and disconnect the regulator from the tank and wait for about 30 seconds. Then reconnect the regulator and open the tank valve slowly.

2.Warning!!! For your safety ALL propane appliances like gas grills, heaters and stoves are OUTDOOR Use.

3.Cecking this hose both end must be fully tightened and keeping the hose away from HIGH TEMPERATURE.

4.To check and make sure the hose is away from the OPEN FIRE before installing to your appliances.

Product Features

• 👍Top quality propane regulator and Stainless Braided hose ,maxing out at 80, 000 BTU, this 2FT Low Pressure Propane Regulator is fiber reinforced to ensure quality performance.Used to connect your propane appliance to 5-40 lb gas tank.
• 👍New upgrade, Propane regulator hose with gauge can detect dangerous leaks and read fuel level at glance. No need to install an extra gas gauge.
• 👍Easily to install .Please double check your appliance connection is 3/8″ Male Flare Fitting Connector.Insert the black plastic fitting and rotate clockwise to your QCC1/Type 1 propane tank connection place. Then connect the regulator hose end connect to your 3/8″ male flare connector propane appliance.
• 👍Fits most gas grill, patio heater, fire pit table, LP generator, lantern, two burner camping stove, more low pressure device that has 3/8″ male flare connection.
• 👍Built-in detection and safety monitoring systems limit flow in the event of hose or grille failure.100% solid brass construction withstands weather, scratching, denting and corroding.